page 4
Install mounting plate to outlet box using
original screws, spring washers and flat washers
provided with new or original outlet box.* Pull
electrical wiring from outlet box through center
hole in the mounting plate.
*
Note
: It is very important that you use the proper
hardware when installing the mounting plate as
this will support the fan.
Lift motor assembly to mounting plate and slide
slot at one end of motor assembly over j-hook on
mounting plate. This will allow motor assembly to
hang out of the way while wiring.
Tip
: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to below, please use a
qualified electrician.
When fan is secured in place on the mounting
plate, electrical wiring can be made
as follows:
Connect
BLACK
and
BLUE
wire from fan to
BLACK
wire from ceiling with wire connector
provided.
Connect
WHITE
wire from fan to
WHITE
wire from
ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together
from fan to
BARE
/
GREEN
wire from ceiling with
wire connector provided.
If you intend to control the fan light with a
separate light switch, connect
BLUE
wire from fan
to the
BLACK
supply from the independent
switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
4. Mounting Plate Installation.
(cont.)
5. Wiring.
mounting
plate
spring washers
outlet box screws
flat washers
mounting plate
j-hook
GROUND (GREEN OR BARE)
GREEN
motor assembly
*
WHITE
WHITE
BLACK
BLACK
BLUE
GREEN
