6
Fig. 5
5.
Insert remaining motor screws (K), along with lock washers
(M). [Fig. 5] Tighten all motor screws (K) securely.
FINAL INSTALLATION
(continued from previous page)
4.
Insert only one motor screw (K) through blade arm (G) to attach
blade arm (G) to motor using one of the lock washers (M) and
one of the motor screws (K) that were previously removed (Step
5, page 5). Partially tighten motor screw (K). [Fig. 4] Repeat with
remaining blade arms (G).
6.
Raise switch housing plate (H) to motor, allowing the male plug
from the motor to come through the square hole in the switch
housing plate (H). Align slotted holes in switch housing plate (H)
with loosened screws in fitter plate and twist switch housing plate
(H) to lock. Re-insert screw that was just removed, and then
tighten all three screws. [Fig. 6]
G
F
D
Fitter Plate
Fig. 4
F
K
M
G
Male Plug
Male Plug
Female Plug
7.
Remove finial (W) from threaded rod on switch housing plate (H).
Save for later use. Raise switch housing (J) up toward switch
housing plate (H). Connect male plug from motor housing (D) to
female plug from switch housing (J) and carefully arrange wiring
inside of switch housing (J) [Fig. 7] Make sure that the plugs are
connected completely.
8
. Align threaded rod on switch housing plate (H) with hole on the
bottom of the switch housing (J) and push up. Attach finial (W), that
was removed during previous step. Make sure finial is securely
tightened. [Fig. 8]
Threaded
Rod
3.
Position blade arm (G) under blade (F) and attach blade arm (G)
to blade (F) with blade screws (L) and blade washers (N). Do not
tighten blade screws (L) until each blade screw (L) has been
started. Then, tighten each blade screw (L) starting with the one in
the middle. [Fig. 3] Repeat for the remaining blades (F).
Fig. 3
F
G
N
L
Fig. 6
H
Fig. 7
J
H
Fig. 8
J
W
W
Threaded
Rod
Threaded
Rod
H
