page 7
9. Light Kit Assembly.
bulb
Install one 6.5 watt medium base LED
bulb (included).
IMPORTANT
: When replacing bulb,
please allow bulb and glass shade to
cool down before touching.
Align grooves on glass shade with
nodules on inside edge of light kit
fitter and push up gently on glass
shade. Twist glass shade to the RIGHT
(clockwise) until glass shade locks into
place.
Pull down VERY GENTLY on glass shade
to make sure that glass shade is secure.
motor
housing
glass shade
diagram 1
diagram 2
diagram 3
diagram 4
10. Testing Your Fan.
reverse switch
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and wall switch (if applicable). Test fan
speeds with the pull chain labeled FAN located
to the right of the reverse switch. Start at the
OFF position (no blade movement). First pull will
set the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW.
Fourth pull will re-set the fan to OFF setting. Test
light with the pull chain labeled LIGHT located
to the left of the reverse switch. (
diagram 1
) If
fan and/or light do (does) not function, please
refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off
before
moving the
reverse switch (located on light kit fitter). Set
reverse switch to recirculate air depending on
the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the RIGHT
for fan to function. If the reverse switch is set in
the
middle
position (
diagram 4
), fan will not
operate.
Attach pull chain extensions supplied or custom
pull chain extensions (sold separately) to the
ends of the pull chains.
fan
pull chain
extension
motor
housing
light
pull chain
extension
light kit
fitter
