Liteville 601 Mk4, Руководство пользователя, Страница: 7 / 15

- 12 - - 13 -
Bottom bracket/ crankset/ front and rear
derailleur
Mount the two bearing shells and the
crankset according to the manufacturer’s
manual and do not forget to grease the
system thoroughly�
Note: Mind the clearance between the
crank arm and the chain stay as well as
between the right-hand crank arm and
the Syntace SCS chain guide�
Picture displays the clearance between the chain stay and
the crank arm
• Mount the low Direct Mount front
derailleur at the intended socket�
• Mounting Shimano front derailleurs, use
two raised countersunk head screws
(M5 x 10 mm / TX25/ ISO 7380)�
The Shimano derailleur comes with the
two screws as standard or can be ordered
at Syntace (Art� #140882)� For SRAM front
derailleurs, only one of these screws is
needed�
• Make sure that the guide plate of the front
derailleur is parallel with the big chain
ring�
Note: Please mind the different cable
routing options of front derailleurs offe-
red� The Liteville 601 Mk4 is compatible
with front pull design solutions only�
Picture shows: Shimano side swing front derailleur
• Mount and adjust the rear derailleur
according to the manufacturer’s manual
with a suitable rear derailleur hanger
(Direct Mount/ Standard)�
Service Port
At the lower end of the down tube you will
find the ServicePort with which the assem-
bly of the bike including the internal cables
is simplified�
Note: The screw is secured with a safety
ring preventing it from getting lost�
Open the screw with about 3�5 revolu-
tions, yet no further or until you feel a
slight resistance�
Opening the ServicePort:
• Fixate the frame and open the ServicePort
screw with about 3�5 counterclockwise
revolutions�
• Open the ServicePort towards the front
making usage of an Allen key�
• You may now take the ServicePort out of
the frame�
Closing the ServicePort:
• Follow the procedure above in the opposite
directions�
Note: Make sure the ServicePort cap
and its counterpart are not twisted
against each other�
Cable routing
Advice: For the cable routing, we
recommend to use the Park Tool “In-
ternal Cable routing kit” IR-1�2 or the
RockShox Barb Connector SRAM article
# 00�6815�066�030
The picture displays the Park Tool IR-1.2, the RockShox
Barb Connector and the cable pulley assembly tool.
The frame comes with a cable deflection
pulley in each chain stay that allows for
a cable routing free of friction resistance
between the chain stay and the rear
dropout� The package includes an assembly
tool in case the deflection pulley is to be
demounted (Pos� 7)�