Pagina 6 di 8
UP
Down
Enter
Esc
Signal Control Connection
LitesF200 can be operated via either DMX512A and or RDM ready . For dasy chain connection use a -2 x 0,5
mm²
size lead wire plus shield. Connect Pin 1 to ground, 2= data – while Pin 3 = data +. Pins 4 & 5 are not connected.
Ensure that DMX wires and shield do not interfere,nor touch each other as well as they must not touch/interfere with
the body of the unit . (DMX connectors are not provided)
Important note: when DMX is available a red dot will illuminate on the left hand of the display.When
red dot is off no DMX signal is available.
WARNING ! Before powering LitesF200 ensure that all installation(s) procedure(s) have(s) been
properly set and accomplished
DMX OUT
DMX IN
Projector mode settings
When LitesF200 is powered, setup-display will show the software release version The UP,
DOWN, ENTER and ESC buttons will allow the operations of the LitesF200 menu. UP and
DOWN buttons allow to scan menu options, ENTER button allow to select. The ESC button is
to retun to the previous menu or to quit the previous setting.
Menu items
Displayed
message
Allowed or displayed
values
Mode
Addr
001..510
DMX address : as of 1 to 510
Mode
1 ch
2 ch
3 ch
4 ch
5 ch
DMX Operating mode (see next page)
Man
0..255
Manual light output adjustment (This is possible even if no DMX is
resent). Adjusted value will be stored on the internal permanent memory
drUt
..°C
Shows driver operating temperature
LEdt
..°C
Show led operating temperature
PUM
0..100%
Shows current led power (0-100%)
SMOO
FAST
MED
SLOW
DMX data Speed adjustment
GAMM
LInE
qUAd
Dimmer profile selection:
- LinE for linear dimming regulation
- qUAd for tungsten lamp emulation)
booS
Off
on
Boost selection:
off = maximum led power at 90%
on = maximum led power at 100%
PoS
AA
VV
I Display orientation selection:
AA = normal
VV = inverted
StbY
Off
on
Standby display activity:
off = display always switched on
on = display switched off after few seconds of buttons inactivity (only
the right side dot will be lighted to indicate DMX availability)
dEF
Off
on
ON Will restore the default factory values
TiML
..h ..
Shows LED life
TiMU
..h ..
Shows HPLed life
SoFt
Shows Software version
XLR
5
connection
leads description
1
GND
2
DMX-
3
DMX+
4
NC
5
NC
