LITEMAX Litile34, Руководство по эксплуатации

Страница: 10 / 21

Page 10
3.0 Connecting Power To The Litile34 Display
It is important that your new display is installed and operated in accordance with the
instructions provided in this handbook. Failure to do so could result in poor product
performance and may invalidate your warranty.
The power cable should be connected to the power input socket on the back of the
display. There is a power switch on the back of each module for switching the units on
and off.
It is important to make sure that the controller is switched on BEFORE the modules to
ensure the correct boot-up sequence for the modules.
The Modules are powered by 220 to 240V, 50-60 Hz AC single phase mains. An earth
connection is essential (through the mains plug supplied). For installations requiring
more power than available from a single ring main, a three phase supply should be
prepared. Please contact Litemax for further detail if this is required. In-line delay
relays (default 5 seconds per Litile34 module) are recommended if powering up
automatically, to sequence the start of the modules and avoid power surges and tripping
of circuit breakers.
Remarks: Please be noted that you need another independent power source cable input
per each 4 Litile34 daisy chain loop.