12) Free and remove lifting
mechanism (lifting arm, post, and
arm rest) with two people. While
attaching post, use once person to
support post while other inserts
bolts.
13.) Position the lifting mechanism
in the same direction of base legs.
Align holes on post plate with
base. Insert bolts marked Front
and Rear Bolts in corresponding
holes to secure post.
14.) Insert bolts labeled front and
rear in corresponding front and
rear holes on post plate. Hand-
tighten each of the four bolts to
create room for modified Allen
wrench.
15.) Tighten bolts with the Allen
wrench. Remove stickers labeled
front and rear after post is
attached.
11.) Cut and remove plastic wrap
from base.
16.) Locate actuator cord coming
out from the bottom of the post.
18.) Place control box back into
base.
24) The battery capacity display
should display four solid black bars
indicating a full charge. If the dis-
play does not show any solid black
bars check battery connection.
20.) Verify operation by moving
actuator up/down by pressing the
arrows on the hand switch. If hand
switch fails to operate the actua-
tor, check connections going into
the control box.
21.) Cove wires using the small
metal plate
17.) Plug the actuator cord into
the slot on the control box labeled
1. Slot 1 is located next to the larg-
est slot which is used for the hand
switch.
22.)
Carefully
remove
remaining packing material to
prepare
for
use.
Device
assembly is complete!
.
CAUTION: DO NOT over tighten the
bolts.