LiteGait 300MX, Руководство оператора и сервисное руководство, Страница: 20 / 39

20
www.LiteGait.com
1-800-332-9255
CAUTION: SITTING WHILE IN THE LEG STRAPS WILL DISPLACE THE HIP AXIS OF
LOCATION AWAY FROM AND OUT OF THE LEG STRAPS; REPOSITIONING OF THE LEG
STRAPS WILL BE NECESSARY.
Leg Strap Application
1. Wrap Velcro thigh cuff portion below bulk of thigh and above knee so strap does
not interfere with knee function.
2. Strap should be perpendicular to ground and pointing up toward the hip on the
outside of leg.
3. Connect male buckles on leg straps into plastic groin piece female buckles.
4. Tighten all three straps keeping center strap perpendicular to the ground and on
the lateral surface of the leg. The bifurcation point on the strap (where the strap
splits into two) needs to be at the hip joint axis of rotation to maintain symmetry.
5. Straps must be tightened completely, using a two-handed technique and getting
rid of all slack, to properly anchor the harness in place and properly transfer the
support to the thighs.
Harness Application – In Supine
1. Roll patient away from you.
2. Attach groin piece and place harness on patient with half of the harness rolled and
under patient. (Figure 1)
3. Hold harness in place with lowest strap at greater trochanter
4. Roll patient into supine.
5. Pull harness around.
6. Straighten harness. Reach behind patient to feel back buckle position. Check for
symmetry. (Figure 2)
7. Connect front buckles
8. Tighten all 6 side straps with leg straight. (Figure 3)
9.
C
onnect the groin piece to the front buckles and tighten as in previous section.
(Figure 4)
10. Roll patient away from you
11. Tighten back straps of groin piece, removing all slack. (Figure 5)
Quick Check

Harness should be equally spaced from side to side
Figure 2
Figure 4
Figure 5
Figure 1
Using Your Lite Gait®
Set the Left Zero by pressing the SET button.
Figure 3