EPX-410D/420D/430D/810D/820D/830D [
3-7 Channel’s Switching
STEP-1: In the main screen, press
It means the channel will be switched on when its
STEP-2: Press
【
▲
】
or
【
▼
】
to
STEP-3: After setting, press
【
DMX
The switching-off level is 5% lower than switching
switching-off level will be 85%.
By default, the channel mode (refer 3
recall a scene on an ECP panel, it will instantly turn on the channels
If the ECP panel also controls other dimmable loads, it might be not desirable to have some
lamps instantly turned-on, but other dimmable load
By changing channel mode from switch to fade mode can solve this issue.
loads to be turned on when dimmable loads are turning to 80%, you can simply change the channel
mode to fade mode (3-6) and make switching
In some applications, turning switching loads on instantly might b
switching mode would be better.
3-8 Software Version Check
In the main screen, press
【
FCN
】
410D/420D/430D/810D/820D/830D [EUM-B]
Channel’s Switching-on Level Setting
, press
【
FUNC
】
to enter the switch on value setting.
switched on when its level is 52%.
to set the switching-on level from 10% to 90%.
DMX
】
to save.
off level is 5% lower than switching-on level. For example, if switching
By default, the channel mode (refer 3-6) is switch mode. In switch mode, if you press up/down buttons
on an ECP panel, it will instantly turn on the channels in EDX
If the ECP panel also controls other dimmable loads, it might be not desirable to have some
on, but other dimmable loads are turned on for some time.
By changing channel mode from switch to fade mode can solve this issue. If you want the switching
loads to be turned on when dimmable loads are turning to 80%, you can simply change the channel
6) and make switching-on value to 80% (3-7).
In some applications, turning switching loads on instantly might be preferable. Setting channel mode as
Software Version Check
】
in succession to check the software version.
9
to enter the switch on value setting.
on level. For example, if switching-on level is 90%, the
6) is switch mode. In switch mode, if you press up/down buttons or
If the ECP panel also controls other dimmable loads, it might be not desirable to have some switching
If you want the switching
loads to be turned on when dimmable loads are turning to 80%, you can simply change the channel
e preferable. Setting channel mode as
