EN
Page 6
Page 7
4.
Mounting
5.
Maintenance
Check all components for signs of damage before every use. Damaged parts should only be
repaired by a qualified professional or the manufacturer. If carrying out any repairs, only use
original spare parts.
Changing the soldering tip
CAUTION!
Hot soldering tip! Danger of fire and injury!
Allow the soldering tip to cool down before changing it.
Proceed as follows:
•
1. Loosen the clamping screw on the soldering tip with an screwdriver and remove the
soldering tip.
•
2. Insert the new soldering tip until it stops and then tighten the clamping screw.
Disposal
Solder waste is hazardous waste. Observe any local authority waste disposal regulations.
6.
Technical data
Power supply: 230 V, 50 Hz
Power: 170 W
Max. temperature at the burning ring: ca. 600 °C
Heating time: ca. 10 Minuten
Diameter of the burning tip: 19,5 mm
Cable length: 3m
Weight: ca. 650 g
Declaration of conformity
Lister GmbH hereby declares that the product / device described in these instructions complies
with the fundamental requirements and other relevant stipulations of Directive 2004/108/EC and
2006/95/EC. The CE mark confirms compliance with the Directives of the European Union. The
declaration of conformity can be viewed by visiting http://www.lister.de.
