Lister Petter LT and LV Operators Handbook
page 9
Figure 2.4.3 Starting Handle Housing
6. If the cold starting aid was not used
turn the engine slowly for up to 20 turns
to prime the combustion chamber and
lubricating oil system.
7. Firmly hold the handle grip, with the
thumb on top of the grip as shown in
'Figure 2.4.4 Holding the Starting
Handle', and crank the engine really
fast, when sufficient speed is obtained
move the decompressor lever towards
the gear end and continue to crank until
the engine fires.
WARNING
Do not pull the starting handle away from
the engine while cranking.
Retaining a firm grip on the handle, lift
the spring loaded plunger (D), if fitted,
and remove the handle from the
housing.
Figure 2.4.4 Holding the Starting Handle
8. Turn the engine control lever anti-
clockwise to the 'RUN' position.
9. If a variable speed control is fitted
reduce the speed as required.
2.5 Electric Starting
If the engine fails to start within 30
seconds, release the start key, or start
button, and attempt to restart after
allowing sufficient time for all moving parts
to stop.
1. Select the excess fuel position by
gently pulling the engine control lever
(A) outward over the middle catch (B)
and turning it fully clockwise.
Figure 2.5.1 Engine Control
2. Check that the decompressor lever is
towards the gear end.
3. If a variable speed control lever is fitted
move it to the fast position.
4. If the ambient temperature is below -
10°C (14°F) refer to items 2. and 3.
in "2.3 Cold Starting Aid".
2. Operating Instructions
- electric starting
