Lista 7993X701, Руководство пользователя

Страница: 34 / 40

34
3) When charging is completed, the light will turn
to green.
4) After fully charged, unplug the charger and
remove the battery pack.
NOTE: If the battery pack is locked in the
charger, press the battery pack release button
and remove it.
WARNING: When battery charge runs
out after continuous use or exposure
to direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some
problems that can arise with battery packs.
Indicator lights indicate problems (see table
below). If this occurs, insert a new battery pack
to determine if the charger is OK. If the new
battery charges correctly, then the original pack
is defective and should be returned to a service
center or recycling service center.
If the new battery pack displays the same
problem as the original Battery Pack, have the
charger tested at an authorized service center.
Light ON/OFF
flash
Status
Red on Charging
Red flash - - - - Defective Bat-
tery
Green on Fully Charged
Green flash - - - - Hot/Cold Delay
The battery chargers and the battery packs
illustrated or described above are not included in
the delivery.
OPERATION
1. STARTING AND STOPPING
BEFORE STARTING YOUR HEDGE TRIMMER
Remove blade sheath as illustrated in Fig C.
C
TO START YOUR HEDGE TRIMMER
(SEE FIG. D)
Your trimmer is equipped with two switch levers.
Both switch levers need to be pressed for the
hedge trimmer to start. Depress and hold safety
handle switch on front handle and press on/off
switch.
TO STOP YOUR HEDGE TRIMMER
Move hedge trimmer away from cutting area
before stopping.
To stop, release either the safety handle switch
or on/off switch, the Trimmer will stop almost
immediately.
WARNING: If any parts are missing,
damaged or broken, do not operate your
hedge trimmer until all damaged parts have
been replaced or repaired. Failure to do so
could result in serious personal injury.
2. HOW TO USE YOUR HEDGE TRIMMER
Inspect the area to be cut before each use,
remove objects which can be thrown or become
entangled in the cutting blades.
Always hold the Hedge trimmer with both hands
and with the blade away from you before turning
it on.
When trimming new growth, use a wide
sweeping action so that the stems are fed
directly into the blade.
Allow the cutting blades to reach full speed
before entering the material to be cut.
D
1
2