Operation
44
Grinding machine SMD 123 RE
5.8
Replacing the grinding mops
Abb. 28:
Replacing the grinding mops
1
Grinding mop
2
Disk
3
nut
4
Direction of rotation sign
The grinding mops on the left and on the right side of the machine are replaced in the same
manner. In the following the work steps for the left side are described.
Switch off machine (see Section 5.6).
Open left machine door.
NOTE
The nut has a left-hand or right-hand thread, depending on the direction of rotation of the
grinding mop. Nuts with a left-hand thread are marked with an arrow.
Pay attention to the direction of rotation of the grinding mop.
Unscrew nut (3).
Remove the grinding mop (1) with washer (2) from the shaft.
Slide a new grinding mop (1) with washer (2) on the shaft while observing the direction of
rotation according to the sign (4).
Screw the nut (3) on the shaft and tighten with the specified tightening torque
(see Section 7.3).
Set the grinding mop height (see Section 5.9).
