Pulse Output Device
19
Get the latest PDF manual:
https://www.lcmeter.com/resources/technical/manuals
Mobile/online version of this manual:
https://www.lcmeter.com/manuals
Follow these steps to install the POD Extension:
1. Verify that the proper POD Extension Model was
obtained by comparing the driver tang on the POD
Extension to the driver tang on the packing gland
that was removed in Step 5 of the
Retrofit
Installations
section of the
topic
above. There are two types of Packing Gland/POD
Extension driver tangs: blade type and fork type.
Blade type packing glands must be replaced with
blade type POD Extensions. Fork type packing
glands must be replaced with fork type POD
Extensions.
2. Install the POD Extension using the two screws
provided. There are two sets of holes in the POD
and the other is 1½" apart. Line up the holes with
the meter to determine which set to use. Tighten
the screws and torque them to 21-25 inch-pounds.
3. Once the POD Extension is in place, the POD may
be installed onto the POD Extension. Align the
POD Fork Tang with the internal POD Extension
Driver. Use the two screws provided to mount the
POD to the POD Extension using two of the tapped
wrench, tighten the screws and torque them to 21-
25 inch-pounds.
POD Wiring
WIRING CONDUIT SYSTEM
When wiring the POD, the wires must enter through the POD’s conduit hub. For explosion-
proof rated systems (Class I, Div 1), the wiring must be in explosion-proof rated rigid conduit,
or–for high vibration installations–explosion-proof rated braided flexible conduit. The conduit
15
