Rev: 01.15.20
Page 6
CCD-0002221
8.
Place one end of each coaxial cable (Fig. 6A) to the hole of the external cellular antenna prep plate
(Fig. 6B) and slide the wires (Fig. 6C) into the far end of the slot area (Fig. 6D) to keep the wires in place.
A
B
Fig. 5
F.
Measure and mark the same distance in step 5E on the trace outline of the roof's surface.
Measure from the bottom side up towards the center, mark the location on the roof's surface.
6.
Before any cuts are made to the roof of the unit:
A.
Make sure the supplied coaxial cables will reach from the roof antenna's marked location to the
internal prep plate.
B.
Make sure that there are no wires, pipes or tubing underneath the marked areas before cutting
and drilling.
7.
Using the center point of the intersecting lines (Fig. 4B), use a sharp cutting tool to crosscut the rubber
roof 3/4
"
in each direction (Fig. 5A
—
orange lines).
A.
Peel the corners of the rubber roof back.
B.
Drill a 1/2" inch hole (Fig. 5B
—
orange circle) at the center of the cuts. This is the cellular antenna
coaxial cable access hole for passing the cables through the unit to the internal prep plate.
Fig. 6
A
B
D
C
