Rev: 01.15.20
Page 3
CCD-0002221
Moving parts can pinch, crush or cut. Keep clear and use caution.
Resources Required
Fig. 1
A
• 1-2 people, depending on the task
• Cordless or electric drill or screw gun
• Appropriate drill bits
• Appropriate drive bits
• Sharp cutting tool
• All weather silicone sealant
• Tape measure
• Straightedge
• Non-permanent marking method
• Strain reliefs for electrical wire
• Four #8 x
3/4
" stainless steel Phillips pan head screws
Preparation
1.
Make sure unit is supported in accordance with manufacturer's recommendations.
2.
Make sure the mounting surfaces for the internal prep plate (Fig. 1A) and external cellular antenna
prep plate (Fig. 1B) are flat and clean
—
free of dust, grime and oils.
Installation
NOTE:
Orange lines indicate where material is being removed, either by cutting, grinding or some other
method. Green lines indicate a designated area. White lines with black borders indicate where
marking on an object with a permanent or non-permanent marking method is required.
B
C
