Rev: 09.15.20
Page 6
CCD-0001531
Auto Level Sequence
Note:
Prior to unhitching from the tow vehicle, make sure trailer is parked on a level surface and the tires
are chocked.
1.
After unhitching from tow vehicle, press AUTO LEVEL (Fig. 1F).
Note:
Pressing any button during an Auto Level sequence will abort the auto leveling cycle.
Note:
In order for the hitch recognition feature to function, the auto level sequence MUST be started with
the front of the trailer above level.
2.
Front landing gear will retract, lowering the front of the unit below level, stopping, then lifting the
front end to level the unit front-to-back.
3.
The left side leveling jack extends and raises the roadside of the unit.
4.
The right side leveling jack extends and raises the curbside of the unit, beginning side-to-side leveling.
5.
The front landing gear extend to complete the leveling cycle.
6.
Additional left-to-right or front-to-back leveling may occur, if the controller deems necessary.
Note:
If the auto level sequence does not happen as stated above, check to ensure proper manual function
in all zones.
Hitch Recognition
1.
Turn on touchpad.
2.
Press the LEFT and RIGHT buttons simultaneously (Fig. 1H and 1I).
3.
The front of the trailer will raise to the height where the auto level sequence was started.
Note:
If the auto level sequence was started with the front of the trailer in a below-level condition, the
hitch recognition will not function and the LCD will display “Feature Disabled.” For hitch recognition
to function, the auto level sequence must be started with the front of the trailer above level.
4.
Connect tow vehicle and make sure 5th Wheel and hitch are connected and locked.
5.
Press Up arrow (Fig. 1A) arrow until “AUTO RETRACT” appears in LCD screen.
6.
Press ENTER. System will immediately retract all jacks.
Troubleshooting
Error Codes
To clear an error from the touch pad, repair or otherwise correct the issue, press ENTER. If the error is still
present, the message will be displayed again.
After working to resolve the issue that led to an error code, press ENTER on the touchpad. If the error is till
present, the message will be displayed again. If resolved the error message will clear.
Make sure the trailer is supported at both the front and rear with jack stands before performing any
troubleshooting or service to the trailer. Failure to do so may result in death or personal injury.
