Rev: 11.18.19
Page 13
CCD-0001535
All normal functions will be disabled when the system is in Error Mode.
1.
Auto Level can only commence if running voltage is 12.7V DC or above.
2.
Auto Level operation will halt if running voltage drops to 9.5V DC.
3.
Manual Level operation can be performed at all running voltages above 9.5V DC.
If an error occurs before or during operation, the error will be displayed in the LCD screen (Fig. 1E) and an
alarm will sound. To reset all error or service displays, press RETRACT and ENTER buttons (Fig. 1D and C) at
the same time. Refer to Touchpad Error Codes chart.
Excess Angle
Touchpad Error Codes
Error Text
Description
Excess Angle
Excess slope for auto leveling.
Feature Disabled
Control not zeroed.
External Sensor
Remote sensor short or disconnected.
Out of Stroke
Check campsite for even, level ground and turn engine on - Check
battery voltage under load.
Low Voltage
Turn engine on - Check battery voltage under load.
Function Aborted
Panic stop.
Jack Timeout
Auto mode/Retract timeout.
Auto Level Fail
Unable to level.
Not Configured
Control not zeroed.
Zero Not Set
Control not zeroed.
Battery Voltage
Turn engine on - Check battery voltage under load.
Apply Park Brake to Auto Level
Set parking brake.
Unit has retracted for longer than 50 seconds
Retract timeout, return leveling jacks for service. Latched retract mode.
Unable to Finish Leveling
Move coach to a more level site.
Check Wiring
Touchpad is powered, but not communicating with the controller.
Check pin 1 and 2 of touchpad harness.
Caution, Excess Run Time
Pump run too long in manual mode.
Latched Retract/Service
Check for leaking jack hose or fitting, reset by pressing retract and
enter at the same time.
1.
The control will not operate at extreme slopes i.e., 3.5 degrees front and rear and 3.5 degrees
side-to-side.
2.
If the coach indicates “EXCESS ANGLE” or “JACKS STROKED OUT“ during an auto level cycle, move the
coach to a more level spot.
