Lippert Components Forest River, Руководство владельца

Страница: 7 / 12

Rev: 11.08.19
Page 7
CCD-0001573-07
Maintenance
The Variable Height Table Pedestal requires very little maintenance. The gas struts are sealed in the
cylinders. The only required maintenance involves keeping the columns clean and free of debris.
Adjustment
If a cylinder creeps up after it has been retracted and locked, the collar can be tightened by hand-turning
the thumbscrew (Fig. 6A) on the locking collar (Fig. 6B).
1.
Pull the handle (Fig. 6C) on the locking collar open.
2. Hand-tighten the thumbscrew to pull the edges (Fig. 6D) of the collar closer together, making sure to
leave some gap between the edges.
3. After tightening, make sure that the handle closes correctly. If it is difficult to close the handle, unscrew
the thumbnail slightly then try closing the handle again.
Troubleshooting
A
B
C
D
What Is Happening? Why? What Should Be Done?
Table will not raise.
Too much weight on the table. Reduce weight or manually assist the table in raising.
Levers are not released.
Check to make sure level is fully released.
Object obstruction.
Make sure there is nothing preventing the table from
raising fully.
Table will not lower.
Locking collar too tight. Check to make sure thumb screw is not too tight.
Levers are not released. Check to make sure lever is fully released.
Object obstruction.
Make sure there is nothing preventing the table from
lowering fully.
Table is creeping
upwards.
Lever is not closed. Make sure lever is fully closed.
Locking collar is too loose. Adjust thumb screw.
Table is creeping
downwards.
Lever is not closed. Make sure lever is fully closed.
Locking collar is too loose. Adjust thumb screw.
Too much weight on the table. Reduce weight on the table.
Fig. 6