Rev: 06.13.18
Page 7
CCD-0001435
Programming the RVLock
1.
Press the lock and unlock buttons on the RVLock remote(s) or, if you have a keypad, type in the
numeric code (default code is 1234) and press the lock button on the keypad to make sure the lock
functions. If they function, go to step 2.
2.
Press the learning button with a paper clip and then release after you hear a short beep. (This button is
located through a pin hole under the interior handle. Lift the interior handle to see the pin hole.)
3.
After you hear the “programming mode” beep, repeat pressing the lock button on your RVLock
remote, or if you have the RVLock keypad, repeat typing in your numeric code and then pressing the
lock button on the keypad until your RVLock handle confirms the programming with a series of fast
beeps. You have approximately 10 seconds. (Example: 1-2-3-4 lock, 1-2-3-4 lock, 1-2-3-4 lock) Default
code for all new keypads is 1234. If programming did not work or if you have additional remotes/
keypads to program, repeat steps 2 and 3.
4.
You have successfully finished the installation! Please always keep keys on the outside of the coach to
avoid accidental lock out.
NOTE:
Make sure to place your keys and these instructions in the glove box of your truck or somewhere on
the outside of the trailer, so they are available when and if you need them. Do not place your keys
or these instructions in the trailer.
Programming a new code into your RVLock Keypad
1.
Write your desired “new” code down and then read through all instructions before you start the
programming process as this will make the programming much easier.
2.
While holding down the “0” button, press and release the “lock” button, then release the “0” button as
well. (You will hear a long confirmation beep – this signifies that you have entered the programming
mode).
3.
Type in the keypads existing code, for example 1234, then press lock. (1234 is the default code from
the factory and only works until it has been changed).
4.
Now type in the new code written down (up to 8 digits), then press lock.
5.
Again type in the same new code as written and again press lock. (Repeat this until a long confirmation
beep from the keypad confirms and completes programming.
6.
Test to ensure your new code works by typing in your new code and press the lock/unlock button . The
keypad should confirm the accepted code by a long beep. If not, start again at step #1.
7.
Peel the double stick tape off the back of the Keypad and press firmly on a clean surface. Keypad will
function best when within a closer proximity of the RVLock handle (Within 15-20’).
NOTE:
Keypad will reset to former operation after 10 seconds of being idle during programming mode. If
you make a mistake simply wait 10 seconds and start over.
8.
Long beep – Confirmation/Functioning
9.
Five short beeps – Error/Wrong code
10.
You must always have the current code to change to a new one. There is no reset button or override
code. If the code has been forgotten, the keypad must be replaced.
11.
Always keep your keys outside of your coach in case of electronics/battery failure.
12.
The CR2032 battery can be accessed by removing the two screws that hold the battery door in place
on the bottom of the keypad.
13.
After installing a new battery, make sure to press battery door in firmly while tightening screws. This
will allow the gaskets to seal up tight. Not pressing the battery door securely while tightening may
result in water being able to access the interior of the keypad.
