Lippert Components ELECTRIC SLIDEOUT SYSTEM, Руководство по эксплуатации и обслуживанию

Страница: 6 / 20

B
C
MANUAL OPERATION
The Lippert Electric slide comes with a manual over ride system. Locate the crank
extension with pin outside of the chassis main rail as, Fig. 2, page 7, shows
underneath the unit on the end of the motor (If your crank extension is under the
inside of the frame, please refer to page 8). This is where the crank handle
(standard fifth wheel landing gear crank handle or 3/4” socket and ratchet fits on to
allow the manual extension/retraction of the room, Fig. 4-5, page 8. Simply take
the crank handle (through-frame models) or wrench, ratchet or drill with a nut driver
(in-frame models) and rotate it clockwise to retract and counterclockwise to
extend slide-out. It is important to note that you DO NOT need to attempt to
disengage the motor as the actuator is “manual ready” Just hook up and crank.
Use EXTREME CAUTION when extending and/or retracting room using the
manual override feature. It is possible to operate the slideout beyond the
maximum extension and/or retraction and damage the slide components, slide
room structure or trim components.
Fig.1
6
WARNING!
Always disconnect battery from system prior to manually operating system. Failure
to disconnect battery can cause electricity to backfeed through the motor and
cause serious damage to the system as well as void the warranty.
WARNING!
The gears can be stripped out if the room is manually retracted/extended to it’s
fullest extent and the operator continues to rotate manual override.
Any damage due to misuse of the Manual Override feature will disqualify any and
all claims to the Limited Warranty.