Rev: 08.29.2014
Page 3
Bauer NE Lock Owners Manual
Fig. 1
B
Operation
The Bauer NE is a 4 touch pad button programmable deadbolt lock (Fig. 1). The 4 buttons are labeled “1|2”, “3|4”,
“5|6”, “7|8”. The button labeled “1|2” is the same button whether the number 1 or 2 is desired. Please note this
handle uses Touch Technology. The buttons are activated by Touch and do not require pressing. Touch the button
and lift finger from button for proper code entry. The following steps show how to operate the Bauer Lock:
1.
Touch the area next to the buttons to "Wake Up" the lock (Fig. 1B).
2.
The buttons will illuminate when the lock is "awake" and will be ready to accept the code.
3.
The factory default code is 3, 7, 1, 5 and is followed by the Enter button (Fig. 1C).
4.
Touch and hold the 3/4 button (Fig. 1A) and Enter button (Fig. 1C) for 2 seconds. The lock will beep 3
times to accept a new code. Enter a 4-digit code followed by the Enter button (Fig. 1C). The lock will
beep 4 times to indicate a new code acceptance. This is now your new code.
NOTE:
Enter your Personal Code upon installation of lock (Step 4) to prevent inadvertent programming.
NOTE:
The touch pad only activates the Dead Bolt. The Paddle Lock is Master Keyed for Dealer and Service
Center use. The Dead Bolt provides Maximum Security.
Calibration and Programming
Preset Factory Code
The Bauer NE has a factory set code of 3,7,1,5 followed by the Enter button. The button with the or the “*” is the
Enter button, and is required to be touched after the code is entered. The factory code resets every time the
batteries are removed for at least 10 seconds.
Programming New Code
To set a new code, touch and hold the “3|4” button and the Enter Buttons for 2 seconds. The Bauer NE will provide
three short beeps, indicating it is ready to accept a new code. Enter the new 4 digit code followed by the “*”. The
Bauer NE will provide four short beeps to indicate new code acceptance. This new code will now activate the lock.
To reset the code, remove the batteries for at least 10 seconds. Re-install the batteries and follow the steps to
Programming New Code.
Maintenance
•
Install fresh batteries as necessary. The Bauer NE is designed to function for months of normal usage with
fresh, high quality AA batteries. Battery life is highly dependent upon battery quality, usage, and environment
(temperature).
•
Make sure there are no obstructions in the door frame to prevent Dead Bolt extension.
•
Do not wash with power washer or high pressure cleaner. The Bauer NE is designed to resist water intrusion to
protect its electrical components from normal water encounter such as rain.
•
The Bauer NE uses Touch Technology. The buttons are activated by touching not pressing.
•
Remove batteries when storing or not using this lock for extended periods of time.
C
A