4
lci1.com
574-537-8900
Rev: 08.20.20
CCD-0003866
Flow Max
™
40V Portable Power Cleaner
Installation and Owner’s Manual
(For Aftermarket Applications)
Fig.3
3.
To only use the 360-degree nozzle
(Fig.4B)
:
A.
Press and hold the lock button
(Fig.4B)
located on the top
of the handle assembly
(Fig.4C)
while inserting the nozzle.
B.
Release the lock button when the nozzle seats into
the handle assembly.
4.
To use the nozzle extension
(Fig.5A)
with the
360-degree nozzle:
A.
Press and hold the lock button
(Fig.5B)
located on the
top of the handle assembly
(Fig.5C)
while inserting the
nozzle extension.
B.
Release the lock button when the extension seats into
the handle assembly.
B
A
B
A
Fig.4
C.
Press and hold the lock button located at the end of the
extension
(Fig.6A)
while inserting the 360-degree nozzle
(Fig.6B)
.
D.
Release the lock button when the nozzle seats into
the extension.
C
D
A
B
Fig.5
Fig.6
Fig.7
A
B
C
B
A
C
Water Supply Line
Make sure the water supply line particle filter is attached
and free of debris.
1.
Unscrew clear plastic filter housing
(Fig.7A)
from the
water supply line
(Fig.7B)
filter end cap
(Fig.7C)
.
2.
Inspect filter
(Fig.7D)
for debris. If necessary, remove
filter and clean.
3.
Reinsert filter, then reattach filter housing to water
supply line filter end cap.
4.
Connect the water supply line
(Fig.8A)
to the handle
assembly
(Fig.8B)
by inserting the quick disconnect
fitting
(Fig.8C)
over the water inlet nipple
(Fig.8D)
until it
seats
(Fig.9A)
.
