Lipco SFB 50, Перевод оригинальной инструкции

Страница: 13 / 20

Instructions Stump cutter SFB 50
13 - 20 150130-04-EN BA SFB 50 / 22.03.2019
11. Working with the LIPCO Stump Cutter
Move the Stump Cutter to the tree stump to be cut. Position the unit
such that the cutter disc is located centrally above the tree stump.
Do not switch on cutting disc while under load. This is why the Stump
Cutter must be lifted to such an extent that it does not rest on the
tree stump when the cutting disc is switched on.
When full speed is reached, lower the stump cutter carefully until the
disc cuts into the wood. Now pivot the stump cutter to the right and to
the left over the tree stump, lower the cutter and repeat the cutting
process until the desired working depth is reached.
•
Attention!
Any adjusting work must be carried out with the excavator
engine switched off! In case of vibrations, immediately stop
working and inspect the cutting blades. Due to the high
speed, an imbalance might be caused by missing or
seriously damaged cutting blades.
•
Only work with the personal protection equipment! (Eye and ear
protection and safety shoes)
•
Attention!
When working in hillside position, the relevant safety
regulations of the traction vehicle manufacturer must be
observed!
•
Especially the maximum allowable hillside inclination when
the Stump Cutter is attached to the traction vehicle and the
direction of working must be observed. The tree stump may
only be cut uphill or downhill, never sideways!