Running your locomotive in the TrainMaster Command Control
environment
Y
our Command-equipped
locomotive comes factory-
programmed with an ID# of “1.” To
get your locomotive in action, set
PowerMasters to CMD or set all power
supplies on full (no more than
19 volts). Press
ENG
and
1
on your
CAB-1 Remote Controller. Turn the
throttle or press any command button,
and your locomotive is ready for
Command operations.
Address Locomotive #1
Set PowerMaster to CMD or traditional
power supplies to full throttle (no more
than 19 volts)
Press ENG
Press 1 (the ID#)
Throttle up/press any command button
Example
CAB-1 Remote Controller commands for your locomotive
TrainMaster Command operations
Tender rear coupler
releases.
Coupler
release sounds.
Press
AUX2
to turn
your locomotive’s
headlight on and off.
Press
WSTL/HRN
to
activate the
locomotive’s whistle,
release to discontinue.
Multi-
Whistle steam whistle
sound.
Press
DIR
—the loco-
motive decelerates to a
complete stop; turn the throttle
up, and the locomotive moves in
the opposite direction. There is
no neutral.
Steam air-
release sound.
Press
BELL
once to
activate the bell,
again to discontinue.
Traditional bell sound.
Press
HALT
to shut down
all PowerMaster
electrical output on your
railroad. Stops all Command-
equipped locomotives in operation.
Use
HALT
only in
emergency
situations.
Turn the
THROTTLE
to the right to
accelerate, left to
decelerate.
Speed-
dependent variable steam
chuffing. DynaChuff
dynamic chuffing effect.
Press and hold
BOOST
for extra
power. Release
BOOST
and return to the locomotive’s
previous speed.
Labored chuff.
Press and hold
BRAKE
to slow down or stop.
Release
BRAKE
and return to the
previous speed.
Squealing
brake sounds.
RailSounds sound system effects are in bold italic.
Press
AUX1
to activate
the numeric keypad.
Coupler release
sounds.
Note!
SET
L
M
H
Beneath this panel
18
