Connecting the controller
T
he four controller wires are attached to the terminals on the underside of the switch. The
controller wires were attached at the factory. The connections are as follows: green wire to
THRU, black wire to GND, red wire to OUT, and yellow wire to RSC LIGHTS.
Operating the switch in the TrainMaster Command Control
environment
Y
ou may choose to operate the switch in the TrainMaster Command Control environment
using the Accessory Switch Controller (available separately, 6-14182) or the SC-2 Switch
Controller (available separately, 6-22980). Refer to these manuals for additional information.
You may choose to leave the controller attached to operate the switch without your
CAB-1 Remote Controller.
ASC connections
The Accessory Switch Controller is capable of controlling up to four remote switches at a
time. Wire the switches to the terminals on the back of the ASC unit as illustrated in Figure 9.
1. Attach a wire to the THRU terminal on the switch and connect it to the 1T terminal on the
ASC unit.
2. Attach another wire to the OUT terminal on the switch and connect it to the 1O terminal on
the ASC unit.
3. Attach the final wire to the GND terminal on the first switch and connect it to the COMM
terminal to the right of the 1T and 1O terminals on the ASC unit.
4. Repeat this process for any additional switches, filling the empty switch terminals on the
ASC in the same way.
9
RSC
LIG
HTS
OU
T
GN
D
THR
U
To M
an
ua
l
Co
ntr
olle
r
THRU
GND
OUT
RSC
LIGHTS
To Manual
Controller
Figure 9. ASC connections
Note!
Underside of
the switch
Controller cable
Controller cable
