Operating the accessory
U
se the controller to operate the accessory. Slide
the ON/OFF switch to the ON position to turn on
the lights and start the animation. Rotate the
volume control knob clockwise to turn on the
carnival music and adjust the volume. Refer to
Figure 3,
Figure 3. Controller operations
Note!
Operating your accessory with TrainMaster Command Control
Y
ou may choose to connect your accessory to a SC-2 Switch and Accessory Controller
(available separately, 6-22980) or the Accessory Switch Controller (available separately,
6-14182) for operation in the TrainMaster Command Control environment. Refer to these
manuals for additional information.
Be sure that the ON/OFF switch is in the ON position and the volume is turned up.
Refer to Figure 3 for the location of these controls.
SC-2 wiring and operation
Three wires (not included) are needed to connect your accessory to the SC-2 and a separate
transformer. Refer to Figure 4 on page 5.
1. Attach one wire to the transformer Common/Ground/U terminal and connect it to the
accessory COMM (common) position on the SC-2.
2. Connect one of the terminals on the bottom of the accessory to the accessory ON/OFF toggle
position on the SC-2.
3. Finally, connect the remaining terminal on the bottom of the accessory to the transformer
Power/A terminal.
Use the
AUX2
button on your CAB-1 Remote Controller to toggle the accessory ON and OFF.
ON/OFF
switch
Volume control
knob
Installing the flags
T
welve flags fly at the top of the accessory. Press
the base of each flag into a hole in the canopy
panels. Refer to Figure 2.
4
Figure 2. Flag installation
