17
TrainMaster Command operations
Reprogramming the Command reverse unit to restore features
D
ue to inevitable derailments and static,
it is possible that your Command
reverse unit could someday lose its setup
program. The symptom of this condition
would be unresponsiveness in Command
mode. This can be easily remedied by
“reprogramming” your Command reverse
unit using the following steps.
STEP 1:
Move the switch on your
locomotive from RUN to PRGM.
STEP 2:
Plug in your Command Base.
STEP 3:
Place the locomotive on track,
then turn on power to your track.
STEP 4:
Press
ENG
, then input the
locomotive’s ID#. Press
SET
.
STEP 5:
Press
ENG
, the ID#,
AUX1
, then
press
8
for your locomotive.
STEP 6:
Turn off power to your track and
wait ten seconds.
STEP 7:
Remove the locomotive from your
track, and move the switch from PRGM to
RUN.
STEP 8:
Place the locomotive back on
track, then turn power on to the track.
STEP 9:
Press
ENG
and the ID#, then
operate as normal.
