THE CONTROLS A. THE TIMER
Select the required drying time based on the
recommendations on the control panel.
B. HEAT SWITCH(ES)
Select the required heat setting based on the
recommendations on the control panel.
C. START BUTTON
Press Start button after closing the door and
selecting the required drying time.
PREPARATION
Check care labels inside the garments
.
CARE LABELS YOU MAY FIND ON YOUR FABRICS
Do not tumble dry woollen or wool mixture articles unless the article is labelled as being suitable .This should
avoid shrinkage.
Place delicate articles, e.g.tights, scarves, inside a pillowcase.
To avoid the need to iron easycare polyester/cotton items it is better to only dry small loads (i.e. half fill drum) It is
better to dry small and large articles together.
Fabric softeners, or similar products, should be used as specified by the fabric softener instructions. Do not
overload the dryer or dry large bulky items such as duvets or sleeping bags as it is important that the airflow
through the dryer is not obstructed.
Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol, kerosene, spot removers,
turpentine, waxes and wax removers should be washed in hot water with an extra amount of detergent before being
dried in the tumble dryer.
Items such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed articles and clothes or
pillows fitted with foam rubber pads should not be dried in the tumble dryer.
OPERATION
Open the door.
Load clothes loosely into the drum.
Load sheets first, starting with one corner.
Close the door.
Dry your hands.
Check that the timer is in the ‘0’position.
Plug in the machine.
Select correct heat position, (see programme chart on control panel for recommendations).
The standard cotton programme is suitable to dry normal wet cotton laundry. It is the most efficient programme in
terms of energy consumption for drying wet cotton laundry.
Your appliance is a reversing, large door opening and a full load will typically take 150 minutes and will use
approximately 4.40kWh of electricity. A half load will typically take 85 minutes and will use approximately
2.32 kWh of electricity.
Set the timer to the required time setting (see programme chart on control panel for recommendations).
For energy labeling purposes (EN61121:2005) for a cotton dry load, use the maximum load weight for cotton and
set the timer to the recommended drying time for cotton dry as specified on the control panel.
Press the start button if fitted.
The drum will begin rotating. Reversing drum models will stop periodically to rotate in the reverse direction for a
short time.
