5
U
NPACKING
Unpack carefully. This equipment should be handled with care.
In order to prevent damage during shipping, the batteries for
your unit are not installed. Carefully follow the instructions and
cautions following for correct battery installation.
If you bought your unit at a store, the batteries may be pre-
installed. In either case, retain this manual in a safe place
should you need to replace the batteries in the future.
Check to ensure that the following items are included for the
applicable model ordered:
• Solar powered emergency battery unit.
• Separate box with two batteries (if not pre-installed).
• Removable 3-wire recharging cord.
• Battery spacer ~2"x1"x3/8".
• This manual.
If an item appears to have been damaged in shipment, replace
it properly in its carton and notify the shipper. If any items are
missing, notify LINOR Technology.
The shipping carton along with the handle box (double boxed) is
the safest packing in which the unit may be transported. Save it
for possible future use. The handle box the unit comes in should
not be used alone for shipping, but makes a suitable container
for storing and transporting.
Do not ship with the batteries installed.
S
ERVICE
Other than for replacing the SLA batteries, do not attempt
service to this unit yourself as opening or removing covers may
expose you to dangerous voltage or other hazards. Refer all
servicing to qualified service personnel. If your unit requires
service please contact LINOR Technology for information on
how to obtain service.
B
ATTERY
R
EPLACEMENT
The power storage devices used in this unit are sealed lead acid
batteries (SLA). These batteries are chosen because of their
simplicity, safety and long service life, typically 3 to 5 years
under normal use. However, this comes at the cost of their
weight. For this reason the unit is supplied with the batteries
boxed separately.
Carefully follow this procedure to initially install or replace
the batteries:
WARNING: To prevent electrical shock remove the AC
power cord from the control panel.
WARNING: For further safty remove all other cords from
the control panel.
WARNING: For additional safety disconnect the batteries
by selecting "OFF" or "0" on the BATTERY switch.
CAUTION: This product can and will break if the batteries are
wired incorrectly. LINOR Technology assumes no responsibility
for damaged products due to the user incorrectly attaching the
batteries. Read the instructions through before attempting
battery replacement. If you feel that you are unable to per-form
this operation bring the unit to a small appliance or computer
repair shop.
Use a pair of pliers and a Phillips screwdriver for the
following proceedure.
1. Remove the AC power cord from the control panel.
2. Remove all cords from the control panel.
3. IMPORTANT - Disconnect the batteries from powering the
unit by selecting "OFF" or "0" on the BATTERY switch.
4. Place the unit solar panel down on a clean surface with a
clear space above the unit so the top panel can be laid
down. The LED light should now be facing up. You might
want to put a towel or a piece of cardboard down to protect
the top of a desk or table from being scratched.
5. Remove the four #6 by 3/4 inch screws in each corner and
place the screws in a small container or tray for safe
keeping.
When you remove the cover in the following step
there will be a wire that connects the LED light to the
controller. Be careful not to pull on this wire or it might
break.
6. Carefully lift the cover with the LED light off the rest of the unit.
There is a wire connecting this panel to the main part. Without
moving it too far away, flip the cover over and place at the top of
the main unit.
7. Remove the metal straps (2 pieces) that secure the batteries
by unscrewing the #8 screw from each. Be careful not to
drop the screw into the unit. Put them with the cover
screws.
Содержание OTG 15W
Страница 2: ......