Installation Guide Linear Motors
ENG
NTI AG / LinMot
P01-48-HP-SSCP
Page 21 / 26
•
Then, if the application allows, the slider and the bearings should be lubricated.
The bearings are each greased with 1 g grease LU02. There should only be a light layer of grease on
the inside.
Note!:
Avoid overlubrication!
Finally, grease the slider according to paragraph 3.2 "Assembly of the linear motor".
6.2.3 Cleaning Agents / Lubricants
All LinMot stainless steel motors have a protection class of IP69. Standard cleaning agents in food and
pharmaceutical industries with usual concentration and amount, can be used for the cleaning. If necessary,
the compatibility with the bearing material (PEEK / PPS), the wiper material (NBR FDA) and the cable sheath
material (PUR) must be checked.
Ordering information
Item
Description
Item-No.
LU02-08
Lubricant for linear motors *
(8 g)
0150-1953
LU02-50
Lubricant for linear motors *
(50 g)
0150-1954
LU02-1000
Lubricant for linear motors *
(1000 g)
0150-1955
*
LinMot LU02 Lubricant corresponds to KLÜBERSYNTH UH1 14-31 which was developed for the food
processing industry.
7 Storage, Transport, Installation Altitude
•
Sliders are to be stored and transported only in the plastic containers (with cardboard inlay) provided for
this purpose, or already installed and secured in LinMot P stators.
•
Remove the slider from this plastic containers only for assembling.
•
The storage area must be dry, dust-free, frost-free and vibration-free.
•
Prescribed storage temperature: -
15 °C…70 °C
•
The motor must be protected against extreme weather conditions.
•
The air in the storage area must not contain any harmful gases.
•
The max. installation altitude is 4'000 m above sea level.
•
From 1'000 m, derating of 1 °C per 100 m is to be considered for air cooling.
