Multi Position Controller
E1100-MP / -MP-HC
NTI AG
Installation:
E1100-MP /-MP-HC
/ 03.10.2005
Page 12/16
Power Supply Requirement
Power Supply motor
The calculation of the needed power for the Motor supply is depending on the application and the
used motor.
Power Supply signal
24VDC
min. 100mA
(no load on the outputs)
typ.
1.1A (all
10
outputs
“on” with 100mA load and /Break with no load)
max.
2.1A
(all
10
outputs
“on” with 100mA load and /Break with 1A load)
Regeneration of Power / Regeneration Resistor
There are two possibilities to deal with power regeneration:
Option A:
Connect an additional capacitor to the motor power supply. It is recommended to use
a capacitor >= 10’000
µ
F (install capacitor close to the power supply!)
Option B:
Install a Regeneration Resistor to X1 (RR+ and RR-). The threshold value of the
voltage depends on the used motor voltage power supply. The max. threshold value
must not exceed 88 Vdc.
Item
Description
Art. No.
Capacitor
Capacitor 10’000
µ
F / 100 V
0150-3075
Regeneration Resistor
RR01-10/60 (10 Ohm, 60 W)
0150-3088
Regeneration Resistor
RR01-10/150 (10 Ohm, 150 W)
0150-3090
Ordering Information
Servo Controller
Description
Art. No.
E1100-MP
Multi Position Controller 8 Commands 72VDC/4A
0150-1661
E1100-MP-HC
Multi Position Controller 8 Commands 72VDC/15A
0150-1662
