LinMot C1250-MI-XC-PD-1S, Руководство пользователя

Страница: 23 / 44

Page 23 of 44 NTI AG / LinMot
4 PROFIdrive Parameters
4.1 Parameters
Attention:
Profinet), which can be configured with the distributed LinMot-Talk software.
With these parameters, the PROFIdrive interface can be enabled or disabled.
The LinMot-Talk software can be downloaded from
http://www.linmot.com under the section download, software
& manuals.
4.1.1 PROFdrive/Dis-/Enable
With the Dis-/Enable parameter the LinMot Servo Drive can be run without the Ethernet PROFIdrive Interface
going online. So in a first step the system can be configured and run without any bus connection.
PROFIdrive/Dis-/Enable
Disable Servo Drive runs without PROFINET.
Enable Servo Drive runs with PROFINET connection.
IMPORTANT: If the PROFIdrive Interface is disabled, the integrated Netx-ASIC rests in reset state! No
messages will be sent to other devices connected to the PROFINET-Network via the servo drive.
4.1.2 PROFdrive/Byte Order
With the Byte Order parameter the used Byte order of the transmitted data can be defined.
PROFIdrive/Byte Order
reversed Byte order is reversed. For S7 PLC_s select reversed.
not reversed Byte order is not reversed.
4.1.3 PROFdrive/Word Order
With the Word Order parameter the used Word order of the transmitted data can be defined.
PROFIdrive/Word Order
Reversed Word order is reversed.
not reversed Word order is not reversed.
4.1.4 PROFdrive/Monitoring Channels
With these parameters the parameters are defined which are copied to the corresponding monitoring channel.
PROFIdrive/Monitoring Channels
Channel 1 UPID Source UPID for monitoring channel 1
Channel 2 UPID Source UPID for monitoring channel 2
Channel 3 UPID Source UPID for monitoring channel 3