LinMot 0150-5590, Руководство по установке

Страница: 3 / 29

Installation Guide Servo Drives ENG
NTI AG / LinMot C1250-MI Page 3 / 29
1 General Information
1.1 Introduction
This manual includes instructions for the assembly, installation, maintenance, transport, and storage of the servo
drives. The document is intended for electricians, mechanics, service technicians, and warehouse staff.
Read this manual before using the product and always observe the general safety instructions and those in the relevant
section.
Keep these operating instructions in an accessible place and make them available to the personnel assigned.
1.2 Explanation of Symbols
Triangular warning signs warn of danger.
Round command symbols tell what to do.
1.3 Qualified Personnel
All work such as installation, commissioning, operation, and service of the product may only be carried out by qualified
personnel.
The personnel must have the necessary qualifications for the corresponding activity and be familiar with the
installation, commissioning, operation, and service of the product. The manual and in particular the safety instructions
must be carefully read, understood, and observed.
1.4 Liability
NTI AG (as manufacturer of LinMot and MagSpring products) excludes all liability for damages and expenses caused by
incorrect use of the products. This also applies to false applications, which are caused by NTI AG's own data and notes,
for example during sales, support or application activities. It is the responsibility of the user to check the data and
information provided by NTI AG for correct applicability in terms of safety. In addition, the entire responsibility for
safety-related product functionality lies exclusively with the user. Product warranties are void if products are used with
stators, sliders, servo drives, or cables not manufactured by NTI AG unless such use was specifically approved by NTI
AG.
NTI AG’s warranty is limited to repair or replacement as stated in our standard warranty policy as described in our
"terms and conditions" previously supplied to the purchaser of our equipment (please request copy of same if not
otherwise available). Further reference is made to our general terms and conditions.
1.5 Copyright
This work is protected by copyright.
Under the copyright laws, this publication may not be reproduced or transmitted in any form, electronic or mechanical,
including photocopying, recording, microfilm, storing in an information retrieval system, not even for training purposes,
or translating, in whole or in part, without the prior written consent of NTI AG.
LinMot® and MagSpring® are registered trademarks of NTI AG.