Wireless Presentation Gateway
Chapter 3: Connecting the
Wireless Presentation Gateway
1. Connect the serial cable, connected to your monitor or projector, to the
Wireless Presentation Gateway’s “TO Monitor/Projector” console port.
2. Plug the supplied power adapter into the jack on the Wireless Presentation
Gateway’s back panel. Then, plug the other end into a power outlet.
3. Proceed to Chapter 4: The Wireless Presentation Gateway’s Player.
The installation is complete.
5
Power
Red. The Power LED will light up when the Wireless
Presentation Gateway is powered on.
WLAN Act
Green. The WLAN Act LED blinks when the Wireless
Presentation Gateway is active.
WLAN Link
Yellow. The WLAN Link LED indicates the status of the link.
The WLAN Link LED will be lit steadily when the Wireless
Presentation Gateway is connected to the wireless network.
The Wireless Presentation Gateway’s LEDs
Instant Wireless
TM
Series
4
Note: As with any video system, image quality is only as good as
the weakest link in the video signal chain. In most cases, that
weakest link is the infrastructure cable. This especially holds true
for wireless transmission systems. To achieve the best possible
image quality with a wireless system, dedicate as much bandwidth
as possible to the video presentation.
Figure 2-2