5
Section 2 Hardware Installation
2-1 Equipment Requirement
Installation requirement:
1.
An A/C power outlet (100~240V,50~60Hz) which supply the power for the WAP11 V2.2
2.
A 10 Base-T/100 Base-TX (UTP) Ethernet cable drop (RJ-45 connector)
2-2 Hardware Installation
Please follow these procedures while setting up the hardware:
1.
Site Selection
Choose a proper location for your WAP11 v2.2.
In general, the best location to place your WAP11 v2.2 is the center of your wireless coverage, with line of
sight to all your mobile stations.
2.
Adjust the direction of the Antenna
Adjust the direction of the antenna placement to improve the WAP11 v2.2’s performance. Try to place the
antenna in the position which can best cover its BSS. Normally, the higher you place the antenna, the better
the performance will be. The character of diversity enhances the receiving sensitivity.
3.
Connect the Ethernet Cable
Can be connected to the 10 Base-T/100 Base-TX Ethernet network. Connect your UTP Ethernet cable to
the RJ-45 connector of the WAP11 v2.2 and connect the other side of UTP Ethernet cable to a hub.
4.
Connect the Power Cable
Connect the power adapter cable to the DC5V Power Socket of the WAP11 v2.2. ONLY use the power
adapter supplied with the WAP11 v2.2. Otherwise, the product may be damaged.