Wireless Access Point Router with 4-Port Switch
2. I’m having problems connecting to the Internet, what LEDs should be lit
on the front of the Router?
•
Each Router’s LED will light up for any proper connection made on the back of
the Router—whether it is an Ethernet cable or power cord.
For example, the following are typical LEDs that light up once a computer and
a cable or DSL modem are connected:
-
When the Router is turned on (the power adapter is plugged into the
Router), the
Power LED lights up.
-
When an Ethernet cable is properly connected between a PC and Port 4 of
the Router, the
Link/Act, Ful/Col, and 100 LEDs in Column 4 light up.
-
A cable or DSL modem connection causes the
WAN Link LED to light up.
17
Instant Wireless™ Series
The Help section contains the most frequently asked Internet connection ques-
tions. If you have additional setup needs or you wish to get information on the
Advanced Features, please visit
kb.linksys.com or see the User Guide, which con-
tains a Troubleshooting appendix (available on the Setup Wizard CD-ROM).
1. I’m not sure what information I need from my Internet Service Provider
(ISP) to get my network up and running. What questions should I ask?
What type of connection do I have: dynamic IP address, static IP address, or
PPPoE?
•
If I am using a dynamic IP address, I should ask:
-
What is my Host Name (if needed)?
-
What is my Domain Name (if needed)?
•
If I am using a static IP address, I should ask:
-
What is my IP Address?
-
What is my Gateway?
-
What is my DNS?
•
If I am using PPPoE (typically used by DSL ISPs), I should ask:
-
What is my User Name?
-
What is my Password?
After you obtain the information, follow the instructions in the Fast Start - Step 3:
Configure the Router, and use this information to enter on the Setup tab. In the
WAN Connection Type section, refer to the chart on the next page:
16
Help
?
Dynamic IP
Address (DHCP)
1. Select
Obtain an IP automatically
as the WAN
Connection Type.
2. Click the
Apply
button to save the setting.
Perform these steps:
PPPoE
1. Select
PPPoE
as the WAN Connection Type.
2. Enter the
User Name
.
3. Enter the
Password
.
4. Click the
Apply
button to save the settings.
Static IP Address
1. Select
Static IP
as the WAN Connection Type.
2. Enter the
IP Address
.
3. Enter the
Subnet Mask
.
4. Enter the
Gateway Address
.
5. Enter the
DNS
in the 1, 2, and/or 3 fields. You need to
enter at least one DNS address.
6. Click the
Apply
button to save the settings.
RAS or PPTP
If you are using RAS (Singapore SingTel) or PPTP (service
in Europe), check with your ISP for the necessary setup
information.
If you have this type
of connection:
