Link 904 – User Manual
5
where 'M3' is the highest sensitivity
- Press the [STORE] button again
NOTE: We recommend that the microphone is set to the highest
sensitivity unless the location is particularly noisy.
2.2 MESSAGE WAITING SETUP
The Link 904 has two types of message waiting indication,
90 Volt and Line Reversal.
- To set the unit to 90V, switch MW1 (located in the switch
compartment on base of the unit) to LR1.
- To set the unit to Line Reversal set the MW1 switch to
either LR1 or LR2 dependant on the wiring of your
telephone socket.
The switch should be set to OFF if no message waiting is
required on the installation.
2.3 DIAL MODE SETUP
To Link 904 can be set to either Tone or Pulse dialling as
follows:
PULSE - Press [SPEAKER ON][STORE][3][0][STORE]
TONE - Press [SPEAKER ON][STORE][3][1][STORE]
STORE button is located under the memory label.
NOTE: As most installations require Tone dialling, this is set as
default on the unit.
2.4 RECALL SETUP
The Link 904 can be set to either Earth or Timed Break
recall using the following procedure:
EARTH RECALL - Switch SW3 (located in the base of the
unit) to 'ER'
TIMED BREAK RECALL - Switch SW3 to 'TBR'
The default TBR setting is 300ms but can be set to either 100ms
or 300ms as follows:
100ms - Press [SPEAKER ON][STORE][2][0][STORE]
300ms - Press [SPEAKER ON][STORE][2][1][STORE]
Содержание Link 904
Страница 1: ...LINK 904 User guide for Link 904...
