Linkcom Link 680 DECT, Инструкция по эксплуатации

Страница: 11 / 72

DECT GAP Link 680 11
6. OPERATIONAL FUNCTION
Introduction
When your cordless is in standby mode, i.e. no calls or operations are being made, the heading “
HS-1
” appears
on the display (the number identifying the cordless).
6.1 TO ANSWER A CALL
• When you receive a call, both handset and base start ringing, the symbol appears on the display, and both
the red led on the handset locator button and the big white led on the phone base start fl ashing. If your
cordless is directly connected to the telephone line (not via PABX) and the Caller Details Service has been
activated by your server, the caller’s telephone number (if available) appears on the display.
• Press the button to answer the call, the symbol will come up steadily on the display and the base red
led will fl ash.
• To end a call, press again the button, or alternatively replace the handset back in the base. The display
symbol and the base red led disappear.
6.2 MAKING CALLS (MANUAL SELECTION)
• Press button.
• The symbol appears steadily on the display and the base red led starts fl ashing.
• Check that the dial tone is present then key in the number.
• The dialled number appears on the display.
• To end the call, press again the
button or alternatively replace the handset back in the base.
6.3 SPEAKERPHONE
To activate the speakerphone, press the button when the handset is idle or after having pressed the
button.
The speakerphone is active if you can hear the caller voice coming from the speaker and can see the and
symbols on the display
(hold repeatedely the Volume button to adjust the speaker volume). To switch
back to standard from a spekerphone call, just press brie fl y the button.
6.4 PRE-SELECTION
• When handset is idle key in up to 25 digits.
• You can check the digit on the display before starting your call.
• If you make a mistake, press shortly the
DEL
button to clear digits one by one from the display; to clear all
digits, press and hold the
DEL
button.
• When number is checked, press the button to start the call.
• At this point digits are selected and dialled.
• To end the call, press the
button again, or replace the handset back in the base.
Note: If you have a PABX connection you need to pause for a few seconds between dialing the system code
and the actual phone number.
To pause, press the button and a dash “-” will appear on the display.