18
Note:
A. If the RF connection over 80sec and still not established, it might link is lost or the transmitter
is most likely out of range. You may have to verify the range and adjust or shorten the distance
between your HDTV set with the transmitter and the receiver. The maximum video
transmission range for 1080p content is up to 23 feet in line of sight (LOS). < The minimum
range is 6.5 feet. >
B. Please make sure the computer have been power on and switched the signal output to HDMI
out; also try to re-plug the HDMI cable to make sure the HDMI connector had settled well.
C. If there is no video displayed and OSD displayed “Not Supported Format”, this is an indication
that the video frame rate from the computer is not supported, please refer chapter 5 to switch
a supported video timing.
D. If you have more than one pair of WHD10, each transmitter and receiver should be at least 6.5
feet away from one another. If both the transmitter and the receiver exist in the same room,
the suggested the distance between the two is 6.5 feet minimum.
(5)
TRANSMITTER
/RECEIVER Status on OSD vs. buttons:
Press the POWER button on the top of Receiver to enter “Active-Standby mode” from “Active
mode”.
- The OSD Shows: (Display 3secs and then enter Active-Standby mode.)
Press the INFO. button on the top of Receiver, the Signal Quality, Source, Channel and
resolution will be displayed for user reference. Press INFO. button again for exit.
OSD Displayed :
HDMI1 CH10 1280x1024
= OFF
