11
3. Set the quad display mode:
First press buttons
0
of the remote control or cabinet ,so display under Quad
mode,but press the 0 key may not post an image, you need to operate the
followingsteps.
4.Enter the setup menu:
Press the
MENU
key of remote control, pop-up menu like Figure 1, the signal source
menu in red press the
OK
key or the
→
key appears input signal selection menu as
Figure 2, you can choose the signal, as shown below:
5.Settings of the window displays signal
Signal 1, Signal 2, Signal 3, Signal 4 shows a fixed position, but four signal ports can
choose a different input source, as follows:
1.The upper left corner shows AO: VGA port input signal,so the signal 1 select AO:
VGA
2.The lower left corner shows DO: DP port input signal, so the signal 2 select D0: DP
3. The top right corner shows D1: HDMI port signal, so the signal 3 select D1: HDMI
4.The bottom right corner shows D3: Mobile Signal port signal, so the signal 4 select
D3: Mobile Signal
6.The screen mode switching:
