4
dc1508bf
DEMO MANUAL DC1508B
QUick start proceDUre
The DC1508B programming board makes it easy to
program and verify the EEPROM contents of the device.
1. Place jumpers and switches in the following default
positions.
wP:
OFF
aSeL1:
L
aSeL0:
L
S1:
OFF
NOTE: By default, the ASEL jumpers are both set to low.
If you wish to program a device with an offset address
other than 0x5C, adjust the ASEL jumpers appropriately.
Consult device data sheet for details.
2. Connect the DC1613 controller to your PC. Plug the
ribbon cable into connector J1 of the DC1508B pro-
gramming board.
3. Open the socket lid. Place the IC inside with pin 1 located
in the upper left corner. See Figure 4.
figure 4. open Clamshell Lid
4. Close lid. It will snap into place. See Figure 5.
NOTE: Removal and insertion of the IC should be done
with either tweezers or a vacuum suction device, and
also with the power switch S1 set to OFF.
figure 5. DC1613 Ribbon Cable attached and Lid Closed
5. Set the power switch S1 to the ON position. The VDD33
LED will illuminate, indicating the on-chip regulator is
providing internal power.
6. Launch the LTpowerPlay software from your PC. Select
Utilities>Programming Utility from the menu. Click
“…” next to the selection box and select a .proj file to
program the device.