3
3. OPERATION INSTRUCTIONS
- This automatic projector is controlled to create decorative effects, for indoor use
- Don’t turn on the fixture if it’s been through severe temperature difference like after transportation
because it might damage the light due to the environment changes. So make sure to operate the
fixture until it is in normal temperature.
-This light should be keep away from strong shaking during any transportation or movement.
-Don’t pull up the light by only the head, or it might cause damages to the mechanical parts.
-Don’t expose the fixture in overheat, moisture or environment with too much dust when installing it.
And don’t lay any power cables on the floor. Or it might cause electronic shock to the people.
-Make sure the installation place is in good safety condition before installing the fixture.
-Make sure to put the safety chain and check whether the screws are screwed properly when
installing the fixture.
-Make sure the lens are in good condition. It’s recommended to replace the units if there are any
damages or severe scratch.
-Make sure the fixture is operated by qualified personnel who knows the fixture before using.
-Keep the original packages if any second shipment is needed.
-Don’t try to change the fixtures without any instruction by the manufacturer or the appointed repairing
agencies.
-It is not in warranty range if there are any malfunctions from not following the user manual to operate
or any illegal operation, like shock short circuit, electronic shock, lamp broke, etc.
1. ABOUT THIS PRODUCT
Thank you for choosing our moving head. For your own safety, please read this manual before
installing the device. This manual covers the important information on installation and applications.
Please install and operate the fixture with following instructions. Meanwhile, please keep this manual
well for future needs. This moving head wash is made of a new type of high temperature strength of
engineering plastics and cast aluminum casing with nice outlook. The fixture is designed and
manufactured strictly following CE standards, complying with international standard DMX512
protocol. It’s available independently controlled and linkable with each other for operation. And it
is applicable for large-scale live performances, theater, studio, nightclubs and discos. Adapts with
powerful LED lamps which features high brightness and stability. Please carefully open package
when you receive the fixture and check whether it is damaged during the transportation.
2. SAFETY INSTRUCTIONS
This device has left the factory in perfect condition. In order to maintain this condition and to ensure
a safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this user manual. If the device has been exposed to temperature changes due to
environmental changes, do not switch it on immediately. The arising condensation could damage
the device. Leave the device switched off until it has reached room temperature. This device falls
under protection-class I. Therefore it is essential that the device be earthed. The electric connection
must carry out by qualified person. The device shall only be used with rate voltage and frequency.
Make sure that the available voltage is not higher than stated at the end of this manual. Make sure
the power cord is never crimped or damaged by sharp edges. If this would be the case, replacement
of the cable must be done by an authorized dealer. Always disconnect from the mains, when the
device is not in use or before cleaning it. Only handle the power cord by the plug. Never pull out
the plug by tugging the power cord. During initial start-up some smoke or smell may arise. This is
a normal process and does not necessarily mean that the device is defective, it should decrease
gradually. Please don’t project the beam onto combustible substances. Fixtures cannot be installed
on combustible substances, keep more than 50cm distance with wall for smooth air flow, so there
should be no shelter for fans and ventilation for heat radiation. If the external flexible cable or cord of
this fixture is damaged, it shall.
