Step 6: Position the safety shield forward toward the roller and lock the active
bolt.
Remark:
The machine will not power on without the feed table and the safety
shield in the proper positions.
Step 7: Make sure there is still enough slack in the web. Close the rollers with
the knob on the right side of the laminator. With the film draped over the two
heating rollers, and melted or taped together, push one edge of the threading card
between the heating rollers so that the film is firmly positioned. Make sure the
rollers are in closed position. If a threading card is not available, any piece of
card stock or poster board will work.
Step 8: Set the FWD / REV switch to FWD and set the RUN / STOP switch to
RUN. If the film and the card are in the nip (the point where the top and bottom
roller meet), the film and the threading card will start into the laminator and will
pass through both sets of rubber rollers. When the threading card has cleared the
back of the machine, set the RUN / STOP switch to STOP.
CAUTION:
For operator safety, the safety shield must be in position over the
upper heating roller when the machine is ON.
COLD FILM
Step 1: Raising the safety shield.
Remove the active bolt on the shield, raise the safety shield.
Step 2: Follow the diagram to thread the film
Slide the roll film onto the roll shaft (follow the above instruction, do not load
the film in wrong side). Hold the roll film on the core adapter, the core adapter
can hold the core of the roll film, to prevent it rotating. Screwing the bolt on the
core adapter. Put the rolls on the brackets. Make sure it is fully seated.
OPERATION INSTRUCTIONS
8
Top heating roller
Bottom heating roller
Cold film
Top stabilizer bar
Top pull roller
Bottom pull roller
Take-up bobbin
Back paper
