Lincoln SKF 1162, Инструкция по эксплуатации и обслуживанию

Страница: 10 / 12

Troubleshooting
Condition Possible cause Corrective action
The gun doesn’t operate No inlet air pressure Connect air supply
The piston ( 7 ) is stuck Disassemble the gun, inspect for damage
Replace if necessary
Air pressure is too low Check air pressure supply
The pressure is to be higher 40 psi (2,7 bar)
Broken return spring ( 12 ) Replace if necessary
The gun doesn’t operate automatically Air pressure is too low Check air pressure supply The pressure is to be
higher 40 psi (2,7 bar)
The piston ( 7 ) is stuck Disconnect air supply hose and hold on until the
spring is retracted the piston back and cycle the
gun If the gun doesn’t operate disassemble the
gun, inspect for damage Replace the piston if
necessary
The gun cycles but doesn’t pump grease Loss of prime Repeat priming operation
The container is out of grease Check that container has grease
Prime is not achieved after 10 to 15 seconds
of operation
Disconnect the extension hose or rigid extension
and cycle the gun until grease flows from the
outlet
The gun continues to lose prime Air may be trapped in several locations in
container after bulk filling
Empty container, refill and repeat priming
The ball check valve ( 3 ) is not functioning Disassemble check valve, remove ball, clean and
inspect ball seat area
If the gun still doesn’t operate Contact an authorized service center
10