Erasing HomeLink
姞
buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
•
Press and hold the two outer
HomeLink
威
buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
威
is now in the train (or
learning) mode and can be programmed at any time beginning with Step
2 in the
“Programming”
section.
Reprogramming a single HomeLink
姞
button
To program a device to HomeLink
威
using a HomeLink
威
button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
威
button.
Do NOT
release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink
威
button, follow Step 2 in the “Programming”
section.
For questions or comments, contact HomeLink
威
at
www.homelink.com
or
1–800–355–3515.
MESSAGE CENTER
With the ignition in the RUN
position, the message center,
located on your instrument cluster,
displays important vehicle
information
through a constant
monitor of vehicle systems.
You
may select display features on the message center for a display of status.
The system will also notify you of potential vehicle problems with a
display of system warnings followed by a long indicator chime.
2007 MKX
(mkx)
Owners Guide (post-2002-fmt)
USA
(fus)
Driver Controls
92
Содержание MKX 2007
Страница 318: ...318 I n f o r ma t i o nP r o v i d e db y...
Страница 319: ...319 I n f o r ma t i o nP r o v i d e db y...
Страница 320: ...320 I n f o r ma t i o nP r o v i d e db y...