CHECK REAR TURN LAMPS.
Displayed when the turn signals are
activated and at least one is burned out. Check the lamps as soon as
possible and have the burned out lamp replaced.
CHECK TRACTION CONTROL (if equipped).
Displayed when the
Traction Control
y
system is not operating properly. If this message is
displayed on the message center
and
the amber T/C OFF light in the
Traction Control
y
on/off switch is
not
illuminated, the Traction
Control
y
system will be partially operable. If this warning stays on,
contact your dealer for service as soon as possible. For further
information, refer to
Traction control
y
in the
Driving
chapter.
CHECK ADVANCETRAC (if equipped).
Displayed when the
AdvanceTrac
y
system is not operating properly. If this message is
displayed on the message center the AdvanceTrac
y
system will be
partially operable. If this warning stays on while the engine is running,
contact your dealer for service as soon as possible. For further
information, refer to
AdvanceTrac
y
stability enhancement system
in
the
Driving
chapter.
TRUNK AJAR.
Displayed when the trunk is not completely closed.
LOW WASHER FLUID.
Indicates the washer fluid reservoir is less than
one quarter full. Check the washer fluid level. Refer to
Checking and
adding washer fluid
in the
Maintenance and specifications
chapter.
CHECK AC (cabin) FILTER.
Displayed when the A/C cabin filter life
remaining is 5 percent or less. When A/C filter life left is between 5%
and 0%, the CHANGE A/C FILTER SOON message will be displayed.
When A/C filter life left reaches 0%, the AC FILTER CHANGE
REQUIRED message will be displayed.
To reset the A/C filter monitoring system to 100% after each A/C Filter
change:
1. Press the STATUS control to
access the System Check function,
the message center will display A/C
FILTER XXX% RESET FOR NEW.
2. Press and hold the RESET
control to set to 100%, the message
center will display IF NEW FILTER
HOLD RESET.
Driver Controls
97