Lincoln Electric SUBARC 5, Инструкция по эксплуатации и техническому обслуживанию

Страница: 47 / 60

8695 5240 / M
E - OPERATOR MANUEL
SUBARC 5 - DX7
E-41
7 - SAW WELDING CONTROL OF VERSION
SUBARC 5
Press P6 and keep it pressed in (if you do not want to use pre-flux C19)

the flux flows
When the flux is sufficient around the point of impact of the wire, release P6 : the welding can
start.
Before the welding starts up the flux flows for the duration of the timeout (adjustment by C 19).
Once welding is established, improve the adjustments of US and IS with potentiometers P1 and
P5
Press P7 to stop welding
INFORMATION
Storing the welding parameters
It is possible to store the welding parameters by pressing P6 during welding
After welding stops, the parameters taken into account during the pulse are restituted on the
display units
Flux
It is possible to stop the flux flow before the end of welding by selecting position with P4
TWIN ARCS AC + DC
Adjust the starts of the two arcs
0
1
0
1
T
L'arc DC
L'arc AC
T = timeout by C 19 of AC arc
The DC arc is controled by push-button P6 or the external control (diagram E52), after the
timeout C19 of AC arc, the welding of Ac arc is controled automatically.
8 - SA WELDING, CONTROL OF VERSION
D2C SA
W
Refer to the instructions for
D2C SAW
: 8695 6051