Page 12
REDI-MIG
®
Plus 215C, 255C, 255S
IM6016
The following items are required:
1)
A reel of wire of suitable size and type.
2)
A suitable gun and cable assembly with a “Euro” connector
and the correct tip and, if necessary gas nozzle for the
consumable being used. (LINC Gun MIG gun is supplied).
3)
Correct drive rolls for the wire size and type to be used. The
REDI-MIG
®
Plus 215C and 255C are supplied with a 0.8 -
0.9mm drive roller. The REDI-MIG
®
Plus 255S are supplied
with a 0.9 - 1.2mm drive roller. Drive rolls for other types
and sizes are available as spare parts. (See table on page
16).
4) A work return cable and clamp. (Supplied)
5)
Normal welding accessories including helmet or hand
shield with suitable lens, gloves etc.
6)
If a gas shielded process is to be used, a cylinder of
appropriate shielding gas is required. (Regulator/flowmeter
and hose are supplied.) If gas shielding is required, connect
the gas hose.
Remember that gas cylinders may explode if damaged, so
ensure that all gas cylinders are securely mounted. Ensure that
the correct type and size wire feed rolls are fitted. In replacing
wire feed rolls, ensure that the key and keyway are correctly
positioned and tighten the knurled locking screw securely.
Fit a spool of appropriate wire onto the spool so that it turns
clockwise as the wire is fed.
Carefully release the end of the wire from the spool ensuring that
the released end is held to stop the wire from unravelling. Cut off
the end kink to give a smooth straight end of wire.
Obtain a gap between the wire feed roll and the pressure roll
by lifting the cam latch. Feed the wire end into the guide tube,
between the drive rolls, and into the “Euro” connector guide until it
protrudes about 20mm out of the front of the “Euro” connector.
Close the drive rolls by lowering the cam latch ensuring the
rolls firmly hold the wire. Adjust the tension so that wire feeds
smoothly.
Do not over tighten.
Fit the gun and cable assembly onto the “Euro” connector by
slipping the end of wire into the cable wire hole.
Tighten the “Euro” connector lock ring.
Activate the power source; set the wire feed speed to 4 on the dial
and press the gun trigger or wire inch push button (if fitted). The
wire feed roll should turn, feeding the wire further up the gun and
cable assembly. Ensure there are no kinks or sharp bends in the
gun cable and hold the gun trigger or wire inch button until the
wire emerges from the gun. It is good practice to remove the tip
when first feeding a new coil of wire, then refitting over the wire
and tightening. Cut off the end of the wire leaving 10mm to 15mm
stick-out. Select required polarity. See Section 1.5
Section 3 - SETTING UP FOR WELDING
