English
English
4
output is energized 15 seconds following the strike
of the welding arc and will continue to run 5 minutes
following the end of the weld.
The following capabilities are supported:
•
Push-pull (12-pin) connection - Panther™ and
Cougar™.
•
Remote foot pedal or hand amptrol.
•
Standard MIG gun trigger connection.
•
Watercooler CoolArc 50.
WARNING
The POWER WAVE
®
C300 CE is not recommended for
pipe thawing.
Equipment Limitations
•
Maximum spool size is 305mm diameter.
•
Maximum spool weight is 20kg.
•
Wire welding processes are limited to positive
polarity only.
•
Does not operate on single phase power.
Case Front Controls
All operator controls and adjustments are located on the
case front of the Power Wave.
Figure 3
1. Left Display - Shows wire feed speed or amperage.
2. Left Knob - Adjusts value in left display.
3. Main Display - Shows detailed welding and
diagnostic information.
4. Left Button - Changes the Main display to show the
Weld Mode, Inductance or UltimArc™ Control or
Memories.
5. On/Off Switch - Controls power to the Power Wave
C300CE.
6. “+” Output Stud - Connection for electrode
positive.
7. “-” Output Stud - Connection for electrode
negative.
8. Right Display - Shows voltage or trim.
9. Right Knob - Adjusts value in right display.
10. Thermal Light - Indicates when machine has
thermal fault.
11. Set-Up - Lights when machine is in set-up mode.
12. Right Button - Changes the Main display to arc
start, arc end and trigger options.
13. MAIN KNOB - Changes the values on the Main
display.
14. 12-pin Connector - Connection for cross switch
gun, push pull guns, remotes.
Case Back Controls
Figure 4
1. Ethernet Connector
2. Power Cord
3. Gas Connection
4. Circuit Breaker
5. Cooler connections
Internal Controls
5